Instructions: Starting the Magic Mushroom grow kit

1. Take the magic mushroom grow kit, plastic bag and paperclip out of the box. Remove the lid of the mushroom grow kit (store the lid properly). Rinse the lid under running water. You will need it again later (step 7).

2.Place the mushroom grow kit without lid in the plastic grow bag (opening at the top). Slide the opening of the bag under the bottom with the micro perforation pointing upwards. The opening of the bag is now largely closed. You do not have to worry about air circulation.

3. When you see the first small mushrooms ( called pins), you can put the grow bag upright. Do not water! The first magic mushrooms will be visible after about 1 week.

4. Place the mushroom grow kit in an area with enough daylight and at a temperature between 18 °C and 28 °C. NEVER place the grow kit in direct sunlight. Although mushrooms will grow at almost any temperature above 15 °C, 23 °C is the ideal temperature for an optimal harvest. Special heat mats are available to ensure this temperature and not have to heat the entire room.

5. When the mushrooms are slightly bigger as the pins keep the bag a bit open the entire time so the moisture can evaporate (Phase 2). Too much moisture is not good.

The first mushrooms will be visible after approximately 1 week. Your first harvest will be about a week later. Make sure that you harvest before the first spores begin to fall! Freshmushrooms grow kits produce their first harvest fairly quickly. The first buds are already visible after only 1 week. Low and high temperatures may slightly delay this growth process. As soon as the buds are visible, stop spraying the inside of the bag. It usually takes one to two weeks before the mushrooms are fully developed.

6.These kits can produce several mushroom harvests. To do so, fill the kit with clean tap water after the first harvest. This process is known as cold shock. It breathes new life into the mycelium and ensures that enough moisture is present for the mushrooms to grow.

7. Place the lid of the grow Kit back on the kit. Let the kit rest for 12 hours. Open a corner of the lid and drain the excess water. From here you can follow the instructions from step 1 again. This process can be repeated several times.

Growing with heatingmat (use only for this kit)

Place the plastic bag with the Grow Kit in it on the heat mat. Switch the heat mat on. After two days switch the heat mat off and wait until the buds have developed, which usually takes between five and ten days. Then switch the heat mat on again and open the top of the bag a little so the moisture can evaporate.

What to do if the buds haven’t developed after ten days. Take the cake out of the plastic box, put it back in the plastic box on its side and start again with two days with the heat mat.